No hay artículos en el carro
No hay artículos en el carro Acrux7 - cepillo polvo de ilon de 100 mm aspiradora de grabado y fresadora de polvo enrutador CNC
Característica
El limpiador de cepillos es motor de husillo de enrutador CNC.
Accesorios de aspiradora, cepillo polvo máqui de grabado.
Especificaciones:
- Tipo: cepillo polvo de cubierta antipolvo de 100 mm.
- Material: ilon y lo.
- Longitud total: 1 m.
-Diámetro: 100 mm.
- Grosor: 5 mm.
- Color del pincel: negro.
Cómo utilizar:
1. Recubierto el calcomanía multiusos en cubierta antipolvo y cepillo polvo, espera que se seque.
2. Ponlos juntos, esperando 2-3 horas, estará bien.
El paquete incluye:
1 cepillo polvo máqui de grabado de 100 mm
Stephen Peterson
6 de julio de 2025
I installed this, using some self adhesive squares, on my router plate, for the route sled I made. It works very well. Cut the dust down immensely.
William
1 de julio de 2025
I bought this for use in the creation of a dustshoe for a longmill mk2 tabletop cnc. I used rare earth metal magnets for mounting.I found that these bristles were to stiff and knocked the dust shoe off of the mount where it was then eaten by my cnc. May work for your application but just know these are very rigid.
justplainfrank
25 de mayo de 2025
I should have measured things a little closer. My project was oversized by one inch and therefore the brush lacked one inch to fill the space. My bad.
Hernan Hernandez
13 de febrero de 2025
Soft enough to be dragged around by 2A 24V Nema17, stiff enough not to be sucked up by 5hp shop vac (through 15ft of hose**)The roll doesn’t cut that well, but just seal it with a little CA glue.
Marilyn in Chicago
5 de enero de 2025
The quality of the bristles seems great. I like that it is on a flexible band. However cannot give it a 5 til I can determine if the sculptural use for it is successful. This is a review not for those who use it as specified.
Productos recomendados
$368MXN
$ 195 MXN $195MXN